(01) — Cost guide · Minnesota edition

Roof Replacement Cost in Minnesota (2026)

In Minnesota, roof replacement cost for the typical project costs about $11,300 — 1% above the national average of $11,200. The gap comes from labor: Minnesota labor runs at 1.02× the national average, and labor is about 45% of an installed price, so the state figure below scales the labor share only and leaves material prices at national levels. Read the national guide for the full breakdown, then use this page for the Minnesota numbers, city prices and code notes.

$6,050
low end in Minnesota — simple spec
$11,300
typical in Minnesota — most homeowners pay near this
$24,200
high end in Minnesota — premium materials, complex site
$6.66
per sq ft of roof area installed, typical architectural shingle job, Minnesota-adjusted

Typical project used for these figures: a 1,700 sq ft roof (about 17 squares) in architectural asphalt shingles, one old layer torn off. Ranges are 2026 planning figures for a professional installation in Minnesota, derived from the national guide as explained below — always confirm with local quotes.

Minnesota prices vs the national average

Materials for this project are priced nationally — a bundle of shingles or a pallet of panels costs roughly the same anywhere in the country before delivery. Labor is what moves, and Minnesota labor sits at 1.02× the national average. Applying that index to the labor share (about 45% of the installed price) gives the Minnesota range below. If your quotes cluster well outside it, the difference is usually specification — material grade, code extras or site difficulty — not the labor market, and it is worth asking which line moved.

FigureNational averageMinnesotaDifference
Low end$6,000$6,0501% above
Typical project$11,200$11,3001% above
High end$24,000$24,2001% above

For the full national breakdown — what is included, what is billed separately, DIY vs pro, and what drives the price — read the national roof replacement cost guide. The table below re-prices that same breakdown for Minnesota.

Cost breakdown, Minnesota-adjusted

The national guide's line items, with materials held at national prices and labor scaled by the Minnesota index of 1.02. Compare a real bid against this table line by line: if a contractor's labor lines run far above these figures, ask what is different about the job, and if the materials lines run far above, ask for the product grades.

Line itemMaterialsLabor (Minnesota)Total
Tear-off & disposalOne existing layer stripped, hauled and dumped $150 $1,450 $1,600
Decking repair allowanceReplacing a handful of damaged sheets; priced per sheet in most contracts $300 $300 $600
Underlayment & ice-and-water shieldSynthetic underlayment over the field, membrane at eaves and valleys $550 $450 $1,000
Architectural shinglesAbout 17 squares including waste and starter courses $3,300 $2,650 $5,950
Flashing, vents & ridge capStep and chimney flashing, vent boots, ridge ventilation and cap $450 $550 $1,000
Drip edge, starter strip & fastenersMetal drip edge at eaves and rakes, nails and sealants $300 $200 $500
Permits, inspection & cleanupPermit where required, magnetic nail sweep, site cleanup $350 $300 $650
Total for the typical projectState-adjusted from the national breakdown above $5,400 $5,900 $11,300

Typical cost by city in Minnesota

Labor markets differ within a state too. These city figures apply each city's multiplier to the Minnesota typical price for the same project — use them to sanity-check a quote from a specific metro, not as a bid. Rural areas outside these metros often land below the cheapest city shown, while resort and island markets can exceed the highest.

CityTypical project cost
Rochester$10,850
Duluth$10,850
Bloomington$11,300
St. Paul$11,550
Minneapolis$11,750

Minnesota rules, climate and code that change the price

Minnesota enforces a statewide residential code with local enforcement and some of the deepest frost requirements in the country — 60 in in the north, 42 in in the Twin Cities — plus heavy snow loads and a strict energy code. Labor sits just above the national average, but deep footings, snow-load structure and energy-code insulation and air-sealing requirements make Minnesota quotes structurally more expensive than the labor index alone suggests.

Roof Replacement Cost in Minnesota: what to watch

A typical 1,700 sq ft architectural shingle roof replacement in Minnesota runs about $11,300, with most jobs landing between $6,050 and $24,200. Minneapolis runs a little above the typical at about $11,750 and St. Paul about $11,550, while Rochester and Duluth run about $10,850. Minnesota roofing is a cold-climate job: frost requirements run 60 in in the north and 42 in in the Twin Cities, snow loads are heavy, and the state's strict energy code adds insulation and air-sealing requirements that show up in a re-roof quote; permits run under the statewide residential code with footing-depth, snow-load and energy-code checks standard, and the Twin Cities enforce most thoroughly. Ice dams are the state's signature roofing failure, caused by heat escaping into the attic and refreezing at the eaves, so a roof replaced without fixing attic bypasses will dam again in its first winter. Ask for the ice-shield coverage in feet from the eave and the ventilation and insulation plan in writing, because in Minnesota those lines matter more than the shingle brand.

What to ask contractors in Minnesota

Four questions that catch the expensive surprises on this project in this state. Get the answers in writing, on the quote, before you compare prices — two quotes are only comparable when they describe the same job.

  • Permit: Minnesota requires permits for roofing, decks and structural work under the state residential code, with footing-depth, snow-load and energy-code checks standard. The Twin Cities enforce most thoroughly.
  • Specification: Ask for the full material specification — grades, ratings and the code extras in the state notes above — not just a brand name and a total.
  • Labor basis: Ask how the quote treats the Minnesota labor market: a quote far above the $11,300 typical figure should name the extra work, access problem or specification that justifies it.
  • Local references: Ask for two recent jobs in your city, not just your state — city prices above vary by thousands, and a contractor working regularly in your metro knows its permit office and inspectors.

Frequently asked questions — Minnesota

How to read these numbers. Last updated October 2026 · Minnesota figures are derived from the national guide by scaling the labor share (about 45% of the installed price) by the Minnesota labor index of 1.02; materials are held at national prices. State indices are planning-grade figures compiled from published regional cost data, not contractor quotes. Always confirm with local quotes; your quote will vary.