(01) — Cost guide · Colorado edition

Roof Replacement Cost in Colorado (2026)

In Colorado, roof replacement cost for the typical project costs about $11,600 — 4% above the national average of $11,200. The gap comes from labor: Colorado labor runs at 1.08× the national average, and labor is about 45% of an installed price, so the state figure below scales the labor share only and leaves material prices at national levels. Read the national guide for the full breakdown, then use this page for the Colorado numbers, city prices and code notes.

$6,200
low end in Colorado — simple spec
$11,600
typical in Colorado — most homeowners pay near this
$24,850
high end in Colorado — premium materials, complex site
$6.84
per sq ft of roof area installed, typical architectural shingle job, Colorado-adjusted

Typical project used for these figures: a 1,700 sq ft roof (about 17 squares) in architectural asphalt shingles, one old layer torn off. Ranges are 2026 planning figures for a professional installation in Colorado, derived from the national guide as explained below — always confirm with local quotes.

Colorado prices vs the national average

Materials for this project are priced nationally — a bundle of shingles or a pallet of panels costs roughly the same anywhere in the country before delivery. Labor is what moves, and Colorado labor sits at 1.08× the national average. Applying that index to the labor share (about 45% of the installed price) gives the Colorado range below. If your quotes cluster well outside it, the difference is usually specification — material grade, code extras or site difficulty — not the labor market, and it is worth asking which line moved.

FigureNational averageColoradoDifference
Low end$6,000$6,2004% above
Typical project$11,200$11,6004% above
High end$24,000$24,8504% above

For the full national breakdown — what is included, what is billed separately, DIY vs pro, and what drives the price — read the national roof replacement cost guide. The table below re-prices that same breakdown for Colorado.

Cost breakdown, Colorado-adjusted

The national guide's line items, with materials held at national prices and labor scaled by the Colorado index of 1.08. Compare a real bid against this table line by line: if a contractor's labor lines run far above these figures, ask what is different about the job, and if the materials lines run far above, ask for the product grades.

Line itemMaterialsLabor (Colorado)Total
Tear-off & disposalOne existing layer stripped, hauled and dumped $150 $1,500 $1,650
Decking repair allowanceReplacing a handful of damaged sheets; priced per sheet in most contracts $300 $300 $600
Underlayment & ice-and-water shieldSynthetic underlayment over the field, membrane at eaves and valleys $550 $500 $1,050
Architectural shinglesAbout 17 squares including waste and starter courses $3,300 $2,800 $6,100
Flashing, vents & ridge capStep and chimney flashing, vent boots, ridge ventilation and cap $450 $600 $1,050
Drip edge, starter strip & fastenersMetal drip edge at eaves and rakes, nails and sealants $300 $200 $500
Permits, inspection & cleanupPermit where required, magnetic nail sweep, site cleanup $350 $300 $650
Total for the typical projectState-adjusted from the national breakdown above $5,400 $6,250 $11,650

Typical cost by city in Colorado

Labor markets differ within a state too. These city figures apply each city's multiplier to the Colorado typical price for the same project — use them to sanity-check a quote from a specific metro, not as a bid. Rural areas outside these metros often land below the cheapest city shown, while resort and island markets can exceed the highest.

CityTypical project cost
Colorado Springs$11,150
Aurora$11,600
Fort Collins$11,600
Denver$12,050
Boulder$12,750

Colorado rules, climate and code that change the price

Colorado's Front Range labor market runs above average, and its cost drivers are altitude and soil: expansive bentonite soils along the Front Range shift foundations and fence posts unless footings are engineered, hail is a frequent roofing cost driver (impact-resistant shingles are common and sometimes insurance-required), and frost depth is 36 in with snow loads that rise sharply in the mountains. Wildfire-zone rules apply in the foothills and mountain communities.

Roof Replacement Cost in Colorado: what to watch

A typical 1,700 sq ft architectural shingle roof replacement in Colorado runs about $11,600, with most jobs landing between $6,200 and $24,850. Boulder runs about $12,750 and Denver about $12,050, while Colorado Springs runs about $11,150. Colorado roofing is a hail story first: hailstorms along the Front Range are frequent enough that Class 4 impact-resistant shingles are a common upgrade and sometimes an insurance requirement, and a hail-rated quote can save more in premiums and claims than it costs up front. Altitude is the second factor — intense UV at elevation ages shingles faster — and snow loads rise sharply in the mountains, while wildfire-zone rules in the foothills and mountain communities can restrict materials. Ask for the hail rating and the underlayment specification in writing, and if your home is in a foothill community, confirm the materials meet the local wildfire requirements before the crew arrives.

What to ask contractors in Colorado

Four questions that catch the expensive surprises on this project in this state. Get the answers in writing, on the quote, before you compare prices — two quotes are only comparable when they describe the same job.

  • Permit: Colorado cities and counties require permits for roofing, decks and structural work, with expansive-soil footing design and, in foothill communities, wildfire-resistant materials checked at permit review.
  • Specification: Ask for the full material specification — grades, ratings and the code extras in the state notes above — not just a brand name and a total.
  • Labor basis: Ask how the quote treats the Colorado labor market: a quote far above the $11,600 typical figure should name the extra work, access problem or specification that justifies it.
  • Local references: Ask for two recent jobs in your city, not just your state — city prices above vary by thousands, and a contractor working regularly in your metro knows its permit office and inspectors.

Frequently asked questions — Colorado

How to read these numbers. Last updated October 2026 · Colorado figures are derived from the national guide by scaling the labor share (about 45% of the installed price) by the Colorado labor index of 1.08; materials are held at national prices. State indices are planning-grade figures compiled from published regional cost data, not contractor quotes. Always confirm with local quotes; your quote will vary.