(01) — Cost guide · California edition

Kitchen Remodel Cost in California (2026)

In California, kitchen remodel cost for the typical project costs about $30,950 — 13% above the national average of $27,500. The gap comes from labour: California labour runs at 1.28× the national average, and labour is about 45% of an installed price, so the state figure below scales the labour share only and leaves material prices at national levels. Read the national guide for the full breakdown, then use this page for the California numbers, city prices and code notes.

$9,000
low end in California — simple spec
$30,950
typical in California — most homeowners pay near this
$90,100
high end in California — premium materials, complex site
$258.98
per sq ft of floor area, typical minor mid-range remodel, California-adjusted

Typical project used for these figures: a minor mid-range remodel of a 10 × 12 ft kitchen — new semi-custom cabinets in the same layout, quartz counters, mid-range appliances. Ranges are 2026 planning figures for a professional installation in California, derived from the national guide as explained below — always confirm with local quotes.

California prices vs the national average

Materials for this project are priced nationally — a bundle of shingles or a pallet of panels costs roughly the same anywhere in the country before delivery. Labour is what moves, and California labour sits at 1.28× the national average. Applying that index to the labour share (about 45% of the installed price) gives the California range below. If your quotes cluster well outside it, the difference is usually specification — material grade, code extras or site difficulty — not the labour market, and it is worth asking which line moved.

FigureNational averageCaliforniaDifference
Low end$8,000$9,00013% above
Typical project$27,500$30,95013% above
High end$80,000$90,10013% above

For the full national breakdown — what is included, what is billed separately, DIY vs pro, and what drives the price — read the national kitchen remodel cost guide. The table below re-prices that same breakdown for California.

Cost breakdown, California-adjusted

The national guide's line items, with materials held at national prices and labour scaled by the California index of 1.28. Compare a real bid against this table line by line: if a contractor's labour lines run far above these figures, ask what is different about the job, and if the materials lines run far above, ask for the product grades.

Line itemMaterialsLabour (California)Total
CabinetsSemi-custom, installed and levelled; about 35% of the whole budget $8,000 $2,200 $10,200
CountertopsQuartz, about 35 sq ft including the sink cutout and edge profile $2,600 $1,150 $3,750
AppliancesMid-range suite: range, refrigerator, dishwasher, microwave $4,500 $500 $5,000
FlooringLuxury vinyl or mid-range hardwood over the 120 sq ft floor $900 $1,000 $1,900
BacksplashSubway or similar tile, about 30 sq ft, set and grouted $550 $850 $1,400
Plumbing & electricalReconnect in place, code upgrades, under-cabinet lighting circuits $800 $2,200 $3,000
Sink, faucet & hardwareUndermount sink, pull-down faucet, cabinet pulls $700 $400 $1,100
LightingRecessed and under-cabinet fixtures, dimmers $500 $650 $1,150
Paint & finishingWalls and ceiling, trim touch-ups $350 $850 $1,200
Demolition, permits & disposalStrip-out of the old kitchen, permit where required, dump fees $200 $1,000 $1,200
Total for the typical projectState-adjusted from the national breakdown above $19,100 $10,750 $29,850

Typical cost by city in California

Labour markets differ within a state too. These city figures apply each city's multiplier to the California typical price for the same project — use them to sanity-check a quote from a specific metro, not as a bid. Rural areas outside these metros often land below the cheapest city shown, while resort and island markets can exceed the highest.

CityTypical project cost
Fresno$27,850
Sacramento$29,100
Los Angeles$32,200
San Diego$32,800
San Jose$34,700
San Francisco$35,300

California rules, climate and code that change the price

California is the highest-cost labour market in Wave 2, and its code adds cost on top: Title 24 energy rules, seismic bracing and hold-downs, wildfire-zone ember-resistant construction (Chapter 7A) in high-severity zones, and in many cities a licensed contractor is required for any job over $500 including labour and materials. Permits are nearly universal and plan review can take weeks in large cities. Frost is a non-issue in most of the state, but seismic detailing and, in fire zones, non-combustible decking and fencing materials change both specification and price.

Kitchen Remodel Cost in California: what to watch

California kitchen remodels carry the highest labour costs in the country plus Title 24 energy rules that shape lighting, ventilation and appliance choices. Permits and inspections are nearly universal, plan review in large cities can take weeks, and any job over $500 requires a licensed contractor. Seismic detailing matters for tall cabinetry and gas lines, and in wildfire severity zones, material choices near exterior openings follow Chapter 7A. Older Bay Area and Los Angeles homes often hide knob-and-tube wiring or galvanised plumbing behind the walls, so a contingency of 15 to 20 percent is not pessimism here, it is experience. Get the permit, electrical and plumbing scope in writing before the cabinets are ordered.

What to ask contractors in California

Four questions that catch the expensive surprises on this project in this state. Get the answers in writing, on the quote, before you compare prices — two quotes are only comparable when they describe the same job.

  • Permit: Yes — California cities and counties almost always require permits for roofing, decks, fences over 6 ft, solar and structural remodels, and a state-licensed contractor is required for jobs over $500. In wildfire severity zones, expect extra review for ember-resistant vents, decking and fencing materials.
  • Specification: Ask for the full material specification — grades, ratings and the code extras in the state notes above — not just a brand name and a total.
  • Labour basis: Ask how the quote treats the California labour market: a quote far above the $30,950 typical figure should name the extra work, access problem or specification that justifies it.
  • Local references: Ask for two recent jobs in your city, not just your state — city prices above vary by thousands, and a contractor working regularly in your metro knows its permit office and inspectors.

Frequently asked questions — California

How to read these numbers. Last updated October 2026 · California figures are derived from the national guide by scaling the labour share (about 45% of the installed price) by the California labour index of 1.28; materials are held at national prices. State indices are planning-grade figures compiled from published regional cost data, not contractor quotes. Always confirm with local quotes; your quote will vary.